Regulator Inline Adjuster
Regulator Inline Adjuster
Adjust the low pressure orifice while the second stage is pressurized
Two drives allowing compatibility with nearly all second stages
Reversible, one end with with a 0.32 in (8.2 mm) slotted drive and the other with a tapered 5 mm hex drive
Low pressure gauge included for display of the intermediate pressure
Finger tight spin-on attachment for quick service
Components:
Low Pressure Gauge (p/n GB02)
Dual scale gauge 0 to 300 psi and 0 to 20 bar
2.75 in (69.8 mm) diameter
Stainless steel case
Above water use only
Gauge Boot (p/n GP17)
Included with fill checker
Snug fitting, silicone compound for protection of gauge
Reversible Low Pressure Gauge
Swap the gauge from left to right side to allow access to both drives
Hand tighten fittings, no wrench needed
One side: 0.32 in (8.2 mm) slotted drive
Other side: 5 mm hex drive
p/n
TL121